Acer Aspire Zc610 Disassembly Updated Full May 2026

This disassembly guide for the Acer Aspire ZC610 —a 19.5-inch All-in-One (AIO) desktop—is based on its common chassis design. This process is essential for upgrading the RAM, swapping the 3.5-inch HDD for an SSD, or cleaning the cooling system. Preparation & Tools Before starting, power down the PC and unplug all cables. Phillips #0 / #1 screwdriver

For those deep-cleaning dust from the heatsink, replacing a dead CMOS battery, or repairing a faulty power button, this guide gives you the complete roadmap. Take your time, organize your screws, and document each cable with your phone’s camera. Good luck! acer aspire zc610 disassembly full

Stand removal: Locate the small screw cover at the base of the stand. Pry it off with a flat tool to reveal two screws. Remove these screws with a Phillips screwdriver, then slide the stand downward and off the hinge.
Screw hunt: The rear cover is held by multiple screws along the bottom edge and inside the VESA mount area. Remove all visible Phillips screws.
Release the clips: The ZC-610 uses plastic clips around the perimeter. Starting at the bottom edge, insert a spudger between the back cover and the silver middle frame. Gently pry upward to pop the clips. Work your way around both sides, then the top.
Lift the cover: Once all clips are free, lift the rear cover straight up. It may still be attached by a small speaker cable or antenna wire – check before yanking. Disconnect any cables from the motherboard to completely separate the cover.

Place the Acer Aspire ZC610 on a flat surface with the screen facing upwards.
Locate the two screws on the back of the device, near the stand. Remove them using a Torx T8 screwdriver.
Carefully lift the stand off the device.

Releasing Clips: Slowly work your way around the edges. You will hear "pop" sounds as the internal plastic clips release. Avoid using metal tools that can mar the plastic or damage internal ribbon cables. This disassembly guide for the Acer Aspire ZC610 —a 19