1. hw 130 motor control shield for arduino datasheet better
  2. hw 130 motor control shield for arduino datasheet better
Log inCreate a developer account

Hw 130 Motor Control Shield For Arduino Datasheet Better ⚡ Instant Download

The HW-130 motor control shield for Arduino is a widely used, budget-friendly motor driver based on the classic L293D chipset. Often referred to as a clone of the original Adafruit Motor Shield (v1), it is designed to stack directly onto an Arduino Uno or Mega, providing a compact solution for driving multiple motors without messy breadboard wiring. Key Technical Specifications

void loop() // Forward both motors digitalWrite(in1, HIGH); digitalWrite(in2, LOW); digitalWrite(in3, HIGH); digitalWrite(in4, LOW); analogWrite(enA, 200); // Speed 0-255 analogWrite(enB, 200); delay(2000); hw 130 motor control shield for arduino datasheet better

(If helpful: related search suggestions loaded.) The HW-130 motor control shield for Arduino is

6. Wiring Diagram Guide

Setup A: Single Power Source (Recommended)

  1. Battery: Connect positive (+) to the Shield's +M terminal and negative (-) to the -M terminal.
  2. Jumpers: Keep the VIN jumper ON.
  3. Arduino: Plug the shield in. The Arduino will turn on using the battery power.
  4. Motors: Connect Motor A to terminals M1+/M1- and Motor B to M2+/M2-.

// Stop both digitalWrite(IN1, LOW); digitalWrite(IN2, LOW); digitalWrite(IN3, LOW); digitalWrite(IN4, LOW); Battery: Connect positive (+) to the Shield's +M