2021 — Hyt Tc700 Programming Software

To program the HYT TC-700 radio, you primarily need the HT700E Programming Software (often listed as v2.1 or v3.23) and a compatible USB programming cable like the PC26. 1. Getting the Software

Step 4: Configure the Software for First Use

1. Launch the TC700 CPS.
2. Go to Settings → Communication Port → Select COM3 (or your assigned port).
3. Set Baud Rate to 19200 (default for TC700).

⚠️ Prerequisites & Warnings

• Software Source: HYT programming software (often labeled TC-700 CPS) is proprietary. It is not typically available as a free public download from HYT (now part of Hytera). You usually need to obtain this from the dealer who sold you the radios or find it via reputable radio programming resource sites.
• Cables: You will need a dedicated HYT programming cable (usually USB-to-RJ45 or USB-to-K-connector).
• Driver Issues: If your cable uses a generic USB-to-Serial chip (like Prolific or FTDI), you may need to install specific drivers.

Once the hardware is recognized, follow these general steps in the HT700E software: Hyt Tc 700 Software 15 - Facebook hyt tc700 programming software 2021