Icaro Laser Software Manual !!top!! -

Icaro Laser Software Manual: A Comprehensive Guide

6.2 Two‑Point Alignment (for beam steering)

1. Place a target at 1 m, mark the spot.
2. Use Tools → Alignment Wizard.
3. Place second target at 5 m, follow on‑screen instructions to adjust galvos or mirror offsets.
4. Save profile to device (non‑volatile memory).

: Users can easily adjust laser parameters (such as power and speed) within the interface to match specific material requirements. 4. Advanced Features Z-Axis Control icaro laser software manual

• Select the "Z-Axis" tab.
• Click "Find Focus" . The laser will move down until it hits a limit switch (or you can manually enter the mm distance from the lens to the material).
• Pro Tip: For diode lasers, set focus at 1.5mm above the material for deeper engraving into wood.

10. Maintenance

• Weekly: Clean lens and mirrors with recommended solvents and lint-free wipes.
• Monthly: Check belt tension, rail lubrication, and pulley alignment.
• Annually: Replace mirrors/lens if pitted; service fans and exhaust.
• Keep firmware and software up to date; follow release notes before upgrading.