Ivoclar Programat P95 Manual !!install!! -

Title: Mastering High-Strength Ceramics: A Comprehensive Technical Manual and Operational Guide for the Ivoclar Programat P95

Author: Dental Technical Engineering Department Date: October 2023 Subject: In-depth analysis and standard operating procedures for the Ivoclar Programat P95 furnace.

4.3 Glazing / Staining

• Temperature: 750°C – 850°C.
• Vacuum: Partial (300 mbar) for glaze smoothness.

remains a legendary "workhorse" in the industry. Known for its reliability and straightforward design, this furnace is still widely used for firing dental ceramics. Ivoclar Programat P95 Manual

Muffle Cleaning: Periodically run a cleaning program (firing at high heat without vacuum) to remove contaminants. Temperature: 750°C – 850°C

Typical Workflow in a Dental Lab

1. Prepare restoration (e.g., zirconia frameworks) and place in furnace tray.
2. Select material-specific program or load a stored custom cycle.
3. Start cycle; furnace locks (if applicable) and runs programmed ramp, hold, and cool stages.
4. Upon completion and reaching safe temperature, open chamber and retrieve part using heat‑resistant tools.
5. Perform finishing, polishing, or further surface treatment as required.

Calibration Using the P95 Manual’s Procedure

If restorations come out over-fired (too glossy) or under-fired (matte, chipping), run a calibration test. The manual outlines using the "Calib" program with a ceramic calibration pellet. The target temperature difference should be less than 5°C. If higher, adjust the "Temp. Offset" parameter in the service menu (accessible with code 1234). remains a legendary "workhorse" in the industry

4.2 IPS e.max Press / LT / HT

• Muffle Material: Special investment material (e.g., PressVest).
• Temperature: 915°C – 930°C (for e.max).
• Vacuum: 500-600 mbar (starting before plastic point).
• Manual Warning: Never press lithium disilicate above 940°C; it will flow uncontrollably and bond to the muffle insulation.

Tips and Best Practices

as they can damage the furnace's exterior and sensitive components. Ivodent Magyarország Manual Resources