Mcgs Hmi Touch Calibration [Premium]

Introduction

Unlike Windows-based HMIs (which use a digitizer driver), MCGS HMIs run on an embedded RTOS or Linux. Calibration is typically required when the touch is offset by 1–2 cm or after a firmware update. mcgs hmi touch calibration

• Use a finger or recommended stylus to tap precise targets (crosshairs or dots) presented across the display—typically on the four corners and several interior points.
• Apply firm, steady taps; avoid dragging.
• Repeat until the system accepts the calibration.

Confirm: Press "Yes" to the confirmation prompt to start the alignment process. Quick Tips for Best Results Use a finger or recommended stylus to tap