Upgrading the software on your Satlink WS-6979 digital satellite finder is a straightforward process designed to improve signal accuracy, add new satellite data, or fix bugs. Unlike older models that required serial cables, the WS-6979 supports updates directly via its Where to Find Software Updates
Satellites.xml or Channel List from LyngSat or KingOfSat. Load it via USB (FAT32) using the "Data Transfer" menu.Menu > System > Calibration – Point the dish at a clear sky (not the sun) and set Signal to 0% baseline.Never turn off the device or disconnect the cable during the active writing process, as this can "brick" the unit, making it unusable. Official Sources: It is highly recommended to visit the official Satlink Support
Have you successfully upgraded your Satlink WS6979? Share your experience or ask questions in the comments below. And don’t forget to bookmark this guide for your next free upgrade.
Files you need:
Before searching for files, confirm your device's current status:
Upgrading the Satlink WS-6979 firmware can improve signal locking, add support for newer codecs like H.265 (10-bit), and refresh outdated satellite transponder lists. While "free" software downloads are available through various enthusiast forums and community portals, it is critical to verify your hardware version first to avoid "bricking" your device. Essential Pre-Upgrade Checklist
Find the exact firmware version currently available for your specific model.