Mc101 Manual: Sinotimer

Overview

• Press + or – to set the hour.
• Press PROG again to move to minutes.
• Use +/- to set the minutes.

• Terminal 1 (L – Input): Live (Line) from the circuit breaker.
• Terminal 2 (N – Input): Neutral from the circuit breaker.
• Terminal 3 (L – Output): Switched Live going to the load (light, pump, valve).
• Terminal 4 (N – Output): Neutral going directly to the load (or bypassed depending on load).

Thermocouple Input: Connect to the designated input terminals. For 3-wire RTDs, wire the resistor element between terminals 8 and 9, with the third "extra" wire to terminal 10. sinotimer mc101 manual

For detailed configuration, users often refer to the Sinotimer MC-101 Series Manual or technical guides to navigate the menu settings and input/output calibrations. Overview

1. Disconnect power from Terminals 1 & 2.
2. Press and hold the STOP/RST and SET buttons simultaneously.
3. While holding both, re-apply power to the device.
4. Keep holding for 5 seconds until the display shows "8888" or a specific code, then flashes.
5. Release the buttons. The unit is now reset to F-1 and a default time of 1 second.

Scientific Research: Regulating sensitive testing equipment in laboratories. Press + or – to set the hour