Staples 17466 Laminator — Manual
Staples 17466 Thermal & Cold Laminator (also identified under model number
Ensure the green light is on; try a slower feed or a thinner pouch. Pouch is wavy/bubbles Temperature too high Switch to a lower mil setting or turn off to cool down. Machine Jammed Misalignment staples 17466 laminator manual
⚠️ Beware of third-party sites asking for credit card information for a “free manual.” The Staples 17466 manual is a free document. Staples 17466 Thermal & Cold Laminator (also identified
- Turn the laminator off.
- Press the "Reverse" button (if your model has one—look for a small rocker switch on the back). Newer 17466 models lack reverse.
- No reverse button? Gently grab the laminated pouch from the exit side and pull firmly while turning the gear knob (accessible if you open the top flap).
Entry Throat Width: 9.5 inches (Supports up to standard Letter size documents) Pouch Compatibility: 3 mil and 5 mil thickness Lamination Type: Dual mode (Hot and Cold lamination) Warm-Up Time: Approximately 4 to 5 minutes ⚡ Getting Started Turn the laminator off
Step 4 – Prepare the Pouch
- Insert your document into a 3 mil or 5 mil thermal pouch.
- Leave at least ¼ inch (5mm) of pouch border around all document edges.
- Ensure the sealed end of the pouch enters the laminator first.
: Its small footprint makes it easy to store in home offices.
, he knew he had to wait. The machine needed to reach its "Ready" state—a transformation that usually takes between 3 to 5 minutes. Step 2: The Pouch Ritual