Ts1162 Installation Manual ((exclusive))

The TS1162 typically refers to the Tecom 3 LED Remote Arming Station (RAS) used in security systems like ChallengerPlus. However, it may also refer to the IBM TS1162 Tape Drive (part of the 3592 enterprise series) or a Santa Fe Advance100 Dehumidifier (part number 4031955). Please find the installation instructions for each below: рџ›ЎпёЏ Tecom TS1162 Remote Arming Station (Security)

Note: Relay 5 is double-labeled. In firmware, select mode: CO2 or AUX.

Input/Output (I/O): Strip wires to approximately 7mm. Insert them into the terminal block and tighten the screws. Ensure there are no stray strands that could cause a short circuit. ts1162 installation manual

The Challenger system identifies each keypad by its unique RAS address, which must be set manually before the unit is powered up.

1. Clarity and Layout

The manual is generally well-organized, featuring a clean layout with exploded-view diagrams. The TS1162 typically refers to the Tecom 3

4.2 Probe Placement

• Temp/RH Probe: At canopy level (plants) or 5 ft above floor (cells). Shield from direct spray.
• CO2 Probe: 6–8 ft high. CO2 is heavier than air; lower placement reads artificially high.

Specific power needs for the digital control and Wi-Fi compatibility. Maintenance: Changing air filters and basic servicing. resource.gemaire.com 2. Tecom TS1162 3-LED Keypad Tecom TS1162

If screen shows “ERR: NO PROBE”: Check RJ45 connector on bottom. Temp/RH Probe: At canopy level (plants) or 5

3. Visual Aids

The diagrams are the manual's strongest asset. They effectively show the wire routing path (up the A-pillar or behind the headliner) and the pin configurations for the connectors. However, the black-and-white printing can sometimes make it difficult to distinguish between the different wire colors (e.g., distinguishing the ground wire from the power wire in the diagram requires close attention).